-
Victory or MTX?
This guard badge has an MTX nut, but I"ve been told it is 'victory' factory production. However, the size of the pin is WAY to large for the several pobeda nuts that I have. The MTX nut fits very well....anybody know?
I was told it was Айрапетяну 7a.1 but the discussion is on a russian sight so communication is more difficult.
-
04-25-2015 12:24 AM
# ADS
Circuit advertisement
-
by
meyerse
This guard badge has an MTX nut, but I"ve been told it is 'victory' factory production.
ШМ З-Д МПС / Штамповочный механический Завод Министерство путей сообщения
-
That isn't really the question, unless we are miss communicating
I understand the factory MTX, what I don't know is the production of the badge itself. THese nuts sometimes get switched around.
so you are saying the badge itself is not a 'victory' factory production badge?
The individual said while the NUT is MTX, the badge is 'victory'. However, of the many 'victory' factory nuts I have all are way to small to fit this badge.
Last edited by meyerse; 04-25-2015 at 03:24 PM.
-
I just clarify that this is not a MTX nuts
-
Oh! Thank you!
Do you know the maker of the badge itself?
And thank you again for the clarification, very helpful.
-
Manufactured by Pobeda I think , I see a version 7-a 6 following Hayrapetyan classification.
-
by
Dom
Manufactured by Pobeda I think , I see a version 7-a 6 following Hayrapetyan classification.
OK, should the nut look like this (below) then? I have several pobeda badges with this type of nut but they are all way to small to screw onto the badge in the original post.....
Do you have a picture of the 'correct' nut for this badge then if this one is not correct? The ШМ З-Д МПС nut fits well on the badge in the original post and no pobeda nut I have will even come close to fitting.
-
same as you show, can be screwthreaded rod has been replaced ?
Bookmarks