Vehicle ID flag....original?

**Newbie** · 11-09-2012, 09:39 PM

Hey guys, opinions on this flag...seller says 46" wide by 24" high ....however the flag is 60x90 ...do these measurements seem right, flags are not my area at all..but i would like one or two, lol....and were they maker marked? ..... just seems like to nice of a flag to be an original...plus....brass grommets ?????? red flag....no pun intended..lol

**Espenlaub Militaria** · 11-09-2012 09:39 PM

We also buy and trade your items and full collections!

**rbminis** · 11-09-2012, 09:42 PM

Hello,
60x90 is equal to 24x48, and the brass grommets are normal on a vehicle identification flag. Maker marked would be okay.
Ralph.

**Adrian Stevenson** · 11-09-2012, 10:29 PM

Hi Josh, I am a bit wary of this one. I think it is bad.

Check the ink stamped 60x90 marking against others shown on the forum.

Cheers, Ade.

**Newbie** · 11-09-2012, 11:03 PM

Ade........I didn't like it either....a few red flags popped up in my opinion....so I went with my gut and passed on it. Thanks Ade!

**Jerry B** · 11-09-2012, 11:20 PM

by rbminis

Hello,
60x90 is equal to 24x48, and the brass grommets are normal on a vehicle identification flag. Maker marked would be okay.
Ralph.

90cm is 36"

**rbminis** · 11-09-2012, 11:24 PM

by Bond

90cm is 36"

Sorry, must have used my rubber tape measure again by mistake!

Ralph.

**Walkwolf** · 11-09-2012, 11:45 PM

I'm in agreement with Ade, the size marking does looks suspicious.
Too bad, as it looks like it could have been a great display
piece - if it were real.........!