-
-
11-09-2012 09:39 PM
# ADS
Circuit advertisement
-
Re: Vehicle ID flag....original?
Hello,
60x90 is equal to 24x48, and the brass grommets are normal on a vehicle identification flag. Maker marked would be okay.
Ralph.
Searching for anything relating to, Anton Boos, 934 Stamm. Kp. Pz. Erz. Abt. 7, 3 Kompanie, Panzer-Regiment 2, 16th Panzer-Division (My father)
-
Re: Vehicle ID flag....original?
Hi Josh, I am a bit wary of this one. I think it is bad.
Check the ink stamped 60x90 marking against others shown on the forum.
Cheers, Ade.
Had good advice? Saved money? Why not become a Gold Club Member, just hit the green "Join WRF Club" tab at the top of the page and help support the forum!
-
Re: Vehicle ID flag....original?
Ade........I didn't like it either....a few red flags popped up in my opinion....so I went with my gut and passed on it. Thanks Ade!
-
Re: Vehicle ID flag....original?
by
rbminis
Hello,
60x90 is equal to 24x48, and the brass grommets are normal on a vehicle identification flag. Maker marked would be okay.
Ralph.
90cm is 36"
Regards,
Jerry
Whatever
its just an opinion.
-
Re: Vehicle ID flag....original?
by
Bond
90cm is 36"
Sorry, must have used my rubber tape measure again by mistake!
Ralph.
Searching for anything relating to, Anton Boos, 934 Stamm. Kp. Pz. Erz. Abt. 7, 3 Kompanie, Panzer-Regiment 2, 16th Panzer-Division (My father)
-
Re: Vehicle ID flag....original?
I'm in agreement with Ade, the size marking does looks suspicious.
Too bad, as it looks like it could have been a great display
piece - if it were real.........!
Bookmarks