[h=3]e plu·ri·bus u·num[/h]
when dis-assembling something that was not made to be dis-assembled,..the last thing is the first.,..that last thing is
how will it look when it's done. That puts the idea of the pins on the body and the lanyard ring. Getting them apart is
not so difficult,..the trick is to make it appear that it has not been taken apart. I usually start from one side and drill
out the pins, taking care not to damage the grips. Then I drive the pins out from the backside on the internal part
of the other grip if needed. I usually saw the head off the lanyard pin as it is the hardest thing to make look correct.
I then make the repairs and reassemble the whole and use the drilled pins that removed the grip and saw them off
and reverse them using a portion of the stem to show as original and use an actual new pin in the grip, below that
which does not show. The head of the lanyard pin which I had sawed off is bored to receive a smaller pin in the shaft
of what remains,....when it is all done,..it is passable. I suppose now that the newer issue Gravity Knives have gone
up in value,..it is harder to justify cannibalizing one of them for parts. So, there we are at yet another square one,..parts,...
Very well said but I can get another doner knife though for less than 50$ for parts But what would labor be on such repair?
Eric
[h=3]e plu·ri·bus u·num[/h]
I am in and out of the hospital quite a bit this year and starting next week, .it will be the beginning of yet another adventure. If you would not mind waiting a bit until I am back in the saddle,...I could talk with you further about
this. I got your PM's and thank you.
Check out Mr. Wittmanns web page. he does repairs from time to time
Wittmann Antique Militaria
Derek
Thanks Derk he was my next contact I know he can do it. I need to get ahold of him so I can get it fixed.
Eric
[h=3]e plu·ri·bus u·num[/h]
Similar Threads
Bookmarks