-
Re: Need help with some articles, pleeaaaseee
weigh it.........should be 28 grams and slightly convex......I still have doubts, sorry
-
03-12-2009 08:53 PM
# ADS
Circuit advertisement
-
Re: Need help with some articles, pleeaaaseee
John,my head says fake,but i do see SHuCo traits but the badge is fairly well buggered
@ Volkssturm,the pin doesn't match the hinge. The pin looks garden shed jobby & the block hinge looks like it was a scrap badge cannibalisation with home done solder. Does the pin that holds flat pin to hinge look like a DIY job? Stewy
-
Re: Need help with some articles, pleeaaaseee
Also,you cannot go by weight due to the "mutant" hardware,my guess is this h/ware is way heavier than what SHuCo used. Stewy
-
Re: Need help with some articles, pleeaaaseee
well, it is slighty convex, I work right next to a bakery, is it possible to weight it there??
-
-
Re: Need help with some articles, pleeaaaseee
hahahahaha , ok I will meassure it and see where can I weight it; y the way, I´ve been reading the answers you got, what is a DIY work??
-
Re: Need help with some articles, pleeaaaseee
Basically the hinge & pin haven't always been the same item.They only met up when they were added to this badge. Stewy
-
Re: Need help with some articles, pleeaaaseee
mmmm is good and important to know the manufacture process; by the way, how are the dimmensions, so I can size it with a caliper?
-
Re: Need help with some articles, pleeaaaseee
Right dimensions are 61.6mm x 47.2mm. Stewy
-
Re: Need help with some articles, pleeaaaseee
thanks mate, I will size it as soon as I can
Bookmarks