Need help with some articles, pleeaaaseee

[John Brandon]

weigh it.........should be 28 grams and slightly convex......I still have doubts, sorry

[Stewy S]

John,my head says fake,but i do see SHuCo traits but the badge is fairly well buggered
@ Volkssturm,the pin doesn't match the hinge. The pin looks garden shed jobby & the block hinge looks like it was a scrap badge cannibalisation with home done solder. Does the pin that holds flat pin to hinge look like a DIY job? Stewy

[Stewy S]

Also,you cannot go by weight due to the "mutant" hardware,my guess is this h/ware is way heavier than what SHuCo used. Stewy

[volkssturm]

well, it is slighty convex, I work right next to a bakery, is it possible to weight it there??

[Stewy S]

well, it is slighty convex, I work right next to a bakery, is it possible to weight it there??

It ain't a doughnut. Sorry,no the h/ware won't allow a true weight. Calipers for size would help,i can give you the dimensions. Stewy

[volkssturm]

hahahahaha , ok I will meassure it and see where can I weight it; y the way, I´ve been reading the answers you got, what is a DIY work??

[Stewy S]

Basically the hinge & pin haven't always been the same item.They only met up when they were added to this badge. Stewy

[volkssturm]

mmmm is good and important to know the manufacture process; by the way, how are the dimmensions, so I can size it with a caliper?

[Stewy S]

Right dimensions are 61.6mm x 47.2mm. Stewy

[volkssturm]

thanks mate, I will size it as soon as I can