Electrolysis

[Datrus]

I think you should only use iron in the solution. I don't know for sure but it might make some toxic gasses, or react with the item you are cleaning. Again, i don't know for sure what happens if you put brass in the solution, but i don't think it brass will work good with iron objects.

Regards, Lars

[Estland]

Hey,

I used 1.7 mm EU standard copper ground wire.

[Estland]

2.5 mm wire is very good too.
Bigger wire have better electrical conductivity!

[Estland]

It's good to be Useful
Good luck with the cleaning relic.

[don_kihotis7]

Thanks Janar
Lars the wire is made of brass and it helped a lot my circuit. That's why i thought to replace the iron bars with brass/copper pipes. It will boost the electrical conductivity.

[Datrus]

Nothing wrong with brass or copper above the electrolyte solution( the water). I just wrote what i did because i am not sure what will happen when you put it in the solution. For better conductivity copper will be better than brass

Regards, Lars

[don_kihotis7]

I thought it was the same thing
So i need to find copper pipes. I think the ones we use in our houses for the water facilities are copper not brass, so it won't be difficult to find a few.

[Datrus]

Yes the copper tubing in houses are normally copper

Regards, Lars

[Estland]

I thought it was the same thing
So i need to find copper pipes. I think the ones we use in our houses for the water facilities are copper not brass, so it won't be difficult to find a few.

Chris it looks like pretty good idea
I'll try it now and i let know if it works.

[don_kihotis7]

What would we do without this forum ha?