Cool Dan Andy sent me measurements of a 68 shell. I just need to know if i got a 62 or 64.
Cheers
Cool Dan Andy sent me measurements of a 68 shell. I just need to know if i got a 62 or 64.
Cheers
I have an ET68 that I would LOVE to put one of these on, if you've got the extra fabric.
Last edited by ObKrieger; 09-09-2012 at 02:08 PM. Reason: Not an EF66... an ET68 :)
Hello Dan,
There is something "fishy" about your measurements except for the circumference Are you under the influence of the infamous Inch maybe? Below are the measurements of my helmet. I will say it's a 62 judging from the 660-665mm of your 64 lid. Thanks mate.
Front to back skirt 43.5 cm. Side to side 42.5 cm. Circumference 63.5 just under the retaining pins.
Regards, Lars
HI Lars, just measured again - got the same measurements - checked the tape - it is in metric. I measured 4 helmets ( all Quists and all clearly stamped Q64 ) 2 x M35 and 2 x M35. I turned them upside down and measured side to side at the skirt edge and then front to back hooking the tape edge over the visor and measuring back to the skirt edge at rear. I will take some photos with the tape after work today and you can see ....... strange I agree my measurements are quite different to yours????
Dan
" I'm putting off procrastination until next week "
I think what the problem is Dan. I am measuring from skirt to skirt but up around the dome. You measure across right?
Regards, Lars
Similar Threads
Bookmarks