Hello folks haven’t been up here for a while.
May I ask what you think of this badge, these are the only two pictures I have. I know it would be good to have a nice picture of the hinge block but this is what I have to work with. I can’t quite make my mind up about it, the catch plate seems smaller than on other examples of this maker (looks like L/56) and the catch its self is flat wire but seems to have more rounded edges. Also where the fixing pin wraps round the hinge pin, it looks slightly misshaping not filling up the full width. Or am I being to picky.
anyone spot anything else.
Thanks in advance.
Rod
Bookmarks