Combat-relics.com - Top
Display your banner here
Results 1 to 4 of 4

MK 1 Ross Rifle Bayonet Hunting Knife

Article about: Hello, I've had this Bayo/knife conversion for a few years now. I bought it at a flea market I frequent for 40\\$ or so. If I remember correctly a company in the 1940s (PAL?) bought roughly 20

  1. #1

    Default MK 1 Ross Rifle Bayonet Hunting Knife

    Hello, I've had this Bayo/knife conversion for a few years now. I bought it at a flea market I frequent for 40$ or so.
    If I remember correctly a company in the 1940s (PAL?) bought roughly 2000 Ross Rifle Bayonets from the Canadian government to be converted to hunting knifes by cutting the blades down to roughly 7 3/4 inch and milling the lugs flush.
    Its not uncommon to find these without scabbards as they were not given as many scabbards as there were knifes.

    These knifes are almost entirely found within the States and it is unlikely they ever saw theatre use as proved by the sold out of service stamp (*).

    It just so happens the one I found was a Mark 1 with reminents of the 'step' on the cross guard aswell as the muzzle spring still being attached on the inside though most of these conversions were done to Mk 2 bayonets i believe.

    Even if its a shame these were 'chopped up' they are still a neat piece of history, afterall during WW2 hunters were probably using whatever hunting knifes they could get their hands on with production entirely focused towards the war effort.

    Not to mention these are probably some of the best Bayo/Knife conversions I've ever seen.

    MK 1 Ross Rifle Bayonet Hunting Knife MK 1 Ross Rifle Bayonet Hunting Knife

    MK 1 Ross Rifle Bayonet Hunting Knife MK 1 Ross Rifle Bayonet Hunting Knife

    MK 1 Ross Rifle Bayonet Hunting Knife MK 1 Ross Rifle Bayonet Hunting Knife

    MK 1 Ross Rifle Bayonet Hunting Knife MK 1 Ross Rifle Bayonet Hunting Knife


    Apologies for the fuzzier images here. It was hard to get my phone to focus

    Here you can see possible Initials and the Muzzle Spring typical for Mk 1 ross rifle bayonets.
    MK 1 Ross Rifle Bayonet Hunting Knife MK 1 Ross Rifle Bayonet Hunting Knife

    Thanks for any replies or additional comments regarding the history of these conversions!
    Last edited by Mordecai; 08-30-2024 at 08:33 PM. Reason: Corrected length error

  2. #2

    Default

    That's a really interesting knife.
    The first time that I have seen one.
    gregM
    Live to ride -- Ride to live

    I was addicted to the "Hokey-Pokey" but I've turned
    myself around.

  3. #3
    MAP
    MAP is offline
    ?

    Default

    Nice. Any scabbard to go with the knife?
    "Please", Thank You" and proper manners appreciated

    My greatest fear is that one day I will die and my wife will sell my guns for what I told her I paid for them

    "Don't tell me these are investments if you never intend to sell anything" (Quote: Wife)

  4. #4

    Default

    Unfortunately, I do not have a scabbard for mine. The scabbards for these were the standard Ross rifle bayonet scabbards cut down.

    Here is what the cut-down scabbards looked like.

    link to where i got the photo: Attention Required! | Cloudflare

    MK 1 Ross Rifle Bayonet Hunting Knife


    I also found a post on Milsurps by a fellow named 'oldpaul' who quoted a book
    Link:Ross bayo made into a theatre knife

    " From pages 316-317 TRRS.
    "Hunting knives were in short supply in the Second World War which resulted in the conversion of some Ross bayonets and scabbards for this purpose. in March and April of 1944, 2,209 bayonets and 1,963 Mk1 scabbards were declared surplus and sold to William Margolin, 5094 Victoria Avenue, Montreal. He paid twelve cents each for the former and three cents each for the latter. The bayonets and scabbards were shipped to Pal Cutlery Company, Holyoak Massachusetts, for altering.
    The RCMP brought to the attention of the military that the mustering-out of service, or better, the Government Sales Mark, was not on all the bayonets and scabbards sold. The Canadian Sales Mark on released military equipment is two broad arrows point-to-point within the letter"C" and in this case stamped across the pommel and the ground off release button. This was done after the button was screwed down tight to render the bayonet catch unserviceable. The imprint was required to be clear, permanent, and not to obliterate the government markings on the metal or the leather.
    On August 11, 1944, Lieutenant-Colonel B.M.Webb, acting for the Chairman of the A.S. & D.B., immediately rectified the ordinance officer's neglect. Retailers and purchasers, shared the responsibility and were subject to investigation by RCMP.
    This point seemed to be of sufficient concern that a man from the Armourer Shop with dies was sent to the premises of K&G Distributors Limited , 754 Wellington Street West, Montreal, to supervise the making of the knives and scabbards. Two men spent about three weeks doing this, completing the work in the week of August 30, 1944.
    The Wartime Prices and Trade Board (in notification5128 to Wholesalers) listed the "Hunting Knives with Leather Scabbard" for $3.75 each FOB Montreal, sales tax included.
    The same notification stated that the price to retailers was to be $5.00 each FOB Montreal, tax included, and that the retail value was not to exceed $7.50 anywhere in Canadaicon."
    If I read this right, these were not "Fighting" knives, but Hunting knives meant to be sold to the general public. The caption on the bottom of the picture reads,"Plate 366A: Mk1 and MkII bayonets altered to hunting knives. Records found to date indicate only Mk1 bayonets were altered. The right knife(upper) was made from a Mk1 bayonet and the left knife (lower) was made from a MkII bayonet. Regards. Tom "


    From the last bit I am unsure if this means that PAL was only sold Mk1 bayonets on paper and they recieved some Mk2's aswell or that another company perhaps altered mk2 knifes to a similar spec.
    Either way I suppose my "though most of these conversions were done to Mk 2 bayonets i believe." statement is false as it seems mostly Mk 1 bayonets were converted by PAL.
    From what I can tell PAL never marked any of the conversions.

Similar Threads

  1. 1917 Ross Rifle Bayonet

    In Edged weapons
    11-11-2023, 12:59 AM
  2. Canadian Ross rifle bayonet

    In Edged weapons
    12-09-2019, 03:07 PM
  3. Ross Rifle Co, Quebec 1907 bayonet

    In Bayonets and trench knives of the world
    05-25-2017, 02:35 PM
  4. Ross Rifle Bayonet

    In WW1 Allies: Great Britain, France, USA, etc 1914 - 1918
    08-01-2013, 02:50 PM
  5. My new ross rifle bayonet :)

    In Edged weapons
    03-20-2013, 04:23 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Espenlaub Militaria - Down
Display your banner here