-
by
Adrian
The last badge I treated, I coated the affected area in Vaseline and left a thick layer on it. I placed the badge in a glass and covered the glass with cling film and left it for three days. I put it in a glass to keep it from attracting dust and to stop the Vaseline getting everywhere. Then I got some soft paper towel and gently removed the Vaseline. No hard rubbing, just gentle wiping.
Thank You for Your reply!
Would it be incorrect if I would preventively coated the entire badge?
Kind regards
-
12-28-2023 03:22 PM
# ADS
Circuit advertisement
-
I normally apply a decent coat and leave for 48 hrs. Then, I use tissue and Q-tips to remove as much as possible until it does not leave a "shine" from the Vaseline.
Ralph.
Searching for anything relating to, Anton Boos, 934 Stamm. Kp. Pz. Erz. Abt. 7, 3 Kompanie, Panzer-Regiment 2, 16th Panzer-Division (My father)
-
by
Dovahkiin
Would it be incorrect if I would preventively coated the entire badge?
Kind regards
If the amount of zinc pest is quite a bit, cover the entire badge. If there are only small spots, sometimes I will apply liberally only to the spots.
Ralph.
Searching for anything relating to, Anton Boos, 934 Stamm. Kp. Pz. Erz. Abt. 7, 3 Kompanie, Panzer-Regiment 2, 16th Panzer-Division (My father)
-
by
rbminis
If the amount of zinc pest is quite a bit, cover the entire badge. If there are only small spots, sometimes I will apply liberally only to the spots.
Ralph.
In case of my ASA full covering probably would be better; I think it won’t hurt but maybe it can well preserve the rest of the surface
-
I usually just apply to the affected area. No point covering the whole badge in case the finish is fragile.
Looking for LDO marked EK2s and items relating to U-406.....
-
by
Adrian
I usually just apply to the affected area. No point covering the whole badge in case the finish is fragile.
So, If I may ask, what do You think about case of my badge - I think it’s covered more or less everywhere in zinc pest or it’s just this fragile coating at the bottom (around the bayonet and the granade). What should I do?
Kind regards
-
-
by
Dovahkiin
So, If I may ask, what do You think about case of my badge - I think it’s covered more or less everywhere in zinc pest or it’s just this fragile coating at the bottom (around the bayonet and the granade). What should I do?
Kind regards
by
Adrian
I'd cover everywhere below the red line.
Thank You very much, I will do as You say
Kind regards
-
Bookmarks