West German Paratropper Experimental Helmet Modell Römer/LS 1957-1959
Article about: Hello Here is a rare helmet from the family of experimental helmets used by West German paratroopers from the period between 1957 and 1959. I'll be presenting a test helmet every now and the
West German Paratropper Experimental Helmet Modell Römer/LS 1957-1959
Hello
Here is a rare helmet from the family of experimental helmets used by West German paratroopers from the period between 1957 and 1959.
I'll be presenting a test helmet every now and then over the next few months.
In total, at least 12 different helmet shells, 4 interior fittings, 2 straps, different screws, fastening methods and materials were tested during this period.
The goal was to find a good one-piece helmet for the German paratroopers. The two-part NATO / US model M1C had proven to be inappropriate. In the end, in 1959, for reasons of effectiveness, it was decided to adopt an M1A1 shell and a special inner lining for paratrooper helmets from the Schuberth works that had been developed in this way. So only one shell model had to be produced.
Some of the tried-and-tested helmet models from the period between 1957 and 1959 found a new life in the special operations teams of the state police and the GSG9 that were set up in 1973.
The model shown here has a helmet shell from the manufacturer Linnemann & Schnetzer (LS) The shape is very similar to that of the German paratrooper steel helmet M1938 from WW2 (this development was only 19 years old at that time). However, the edge of the helmet is not bordered but has a welded stainless steel rim. The helmet has a rough paint in brown olive RAL 6014 old (slightly darker than RAL 6014 new).
The interior is from the Hans Römer Neu-Ulm company (HRN) and largely corresponds to that which this company installed in its motorcycle helmets from that time. There was originally an insert with a thin layer of foam underneath the leather. The foam has dissolved over time. At the top, the fabric can be adjusted to the head using a cord. The head size cannot be adjusted for safety reasons.
The inner lining is firmly connected to the shell with 6 hollow rivets. There is also a variant with 6 screws.
The straps/chin strap are also from the Römer company and are very elaborately manufactured with various adjustment options. The model here was also the chin strap from WW2. The straps are firmly riveted to the inner ring of the inner lining.
All experimental helmets were produced in small quantities and worn intensively. Many helmets have been repainted several times and show a corresponding state of wear.
This helmet was also heavily worn. The condition is still acceptable. The shell still has its first coat of paint.
regards
Last edited by Sleepwalker; 12-13-2023 at 07:00 PM.
Bookmarks